Category: ATEX

Karl Metcalfe, Technical Support for the AEMT, looks at the knowledge and responsibilities that are expected when it comes to managing electric motors in zoned areas

p.p1 {margin: 0.0px 0.0px 0.0px 0.0px; font: 10.0px Helvetica; color: #424242}

GROUPE LATTY’s new CARTseal B24 cartridge mechanical seal is FDA, CE 1935/2004, ACS and ATEX-approved, which makes it …

Following the recent introduction of the new ATEX Directive 2014/34/EU, Steve Noakes, engineering manager at Pyroban offers guidance on what this means to users and suppliers of explosion proof …

Phoenix Contact’s Radioline system has recently been certified to meet the ATEX and IECEx standards, allowing it to be deployed internationally in any zone-2 areas, subject to gas explosion risks.

Balluff’s Micropulse TA12 explosion-proof linear position transducer has been credited with IECEx explosive atmospheres approval rating to IEC 60079 0/1/26/31, expanding its potential use in …

A new range of calorimetric sensors has been introduced by ifm electronic to make the job of monitoring the flow of media in explosion hazard areas easier.The new system consists of a panel mounted …

The SPeX ATEX single-pole power heavy duty connector from Marechal is designed for use in hazardous environments.To maximise safety, each time the SPeX is connected or disconnected in a potentially …

To ensure compliance with ATEX Zone 2 requirements, rotary vane compressor manufacturer, Mattei, has launched a new range of gas boost compressors.The new range is primarily designed for compressing …

Vega has launched its new PROTRAC range of nucleonic gauging systems that are well suited for measuring level, density, interface and mass flow, and are unaffected by high vessel pressures, …